Programming Your Remote

Follow the steps below to setup or reprogram you remote

Auto Search Method

1. Turn on the equipment that you want the remote control to operate (cable box, TV, or DVR)
2. Press the [DEVICE] button and the {OK/SEL] button simultaneously for 10 seconds. The device LED will turn on indicating that it is ready to be preprogrammed. The LED will remain on for 20 seconds. The next step must be entered with the LED is on.
3. Press the [CH-] button every two seconds or keep it pressed. The remote will emit a series of Power ON/OFF code signals. Release the [CH-] button as soon as the equipment turns off.
4. Press the same [DEVICE] button to store the code. The Device LED will link twice to confirm that the code has been stored.

*If you find you cannot control some aspects of the TV with the remove (like MUTE, INPUT…) repeats steps 1 and 2 then press the [CH+] button every two seconds until the device turns off, then press the device button to store the new code.